I have been loosing my MOP's when I save a file with RhinoCAM's state being asleep. However it saves my tools.
Is this normal?
Is there a way to make a macro that turns RhinoCAM to awake so i could make a save button that wakes RhinoCAM up and then saves?
Thank you
Ryan
RhinoCAM - MOP's Dissapearing......
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
RhinoCAM - MOP\'s Dissapearing......
Hi Ryan,
We are looking into this and will get back to you when we have a solution.
We are looking into this and will get back to you when we have a solution.