Problem creating stock
Posted: Thu Dec 18, 2003 12:43 pm
I am trying to setup to machine a pipe flange. Pipe flange is round and my slug of stock is round.
My pipe flange is radial around the Z axis.
I cant creat cylinder stock to encompass my part. My only options seem to be be radial around X or Y.
This seems either quite short sited by the program or I am missing something.
Why is the bottom of my stock at -0.75?????????
Then I try to do it the SIMPLE way be using the "set part Z" button' now my stock goes to -1.75???????
I try setting my stock to 1.749 (0.001 thick) as near as I can tell it is almost to zero.
I set the stock to 1.75 and it disappears as it cancels itself out.
So far I have know wasted 1.25 hours on an extremely simple job and it still isnt right!
Guys I truly love this software, but some of this stuff is getting ridiculous!
PS service pack 1 really did help thanks.
Derek
My pipe flange is radial around the Z axis.
I cant creat cylinder stock to encompass my part. My only options seem to be be radial around X or Y.
This seems either quite short sited by the program or I am missing something.
Why is the bottom of my stock at -0.75?????????
Then I try to do it the SIMPLE way be using the "set part Z" button' now my stock goes to -1.75???????
I try setting my stock to 1.749 (0.001 thick) as near as I can tell it is almost to zero.
I set the stock to 1.75 and it disappears as it cancels itself out.
So far I have know wasted 1.25 hours on an extremely simple job and it still isnt right!
Guys I truly love this software, but some of this stuff is getting ridiculous!
PS service pack 1 really did help thanks.
Derek