MecSoft Corporation

The RhinoCam plugin is opening VM4. Is there a new version or something I need to change?

Thanks,
John

Here is the help I get from Kalyan- mecsoft . This fixed my problem. (I change some steps in this help)

2. Is it not launching correct version of VisualMill?
In this case, please try the below suggestions
a. Select Start->Run
b. Type in regedit and select ok
c. In the Registry Editor dialog select HKEY_LOCAL_MACHINE->Software->MecSoft Corporation-> RhinoCAM
e. In RhinoCAM delete all the path variables and close registry editor.
f. The rhinocam must work after the above changes.


Leo

Leo,

Thanks. It appears that I had two copies of RhinoCam plugin on my computer. I uninstalled the demo versions, Rhinocam plugins and deleted the registry paths per your instructions. Then reinstalled Rhinocam and all is working well.

Cheers,
John