Depth of vcarved letters
Posted: Tue Oct 17, 2023 7:39 pm
Hello,
Trying to get the full depth V not a flat bottom on a the letters
The cuts are only going to less than a half inch deep.
The stock thickness H is 2"
In the V-Carving Cut Parameter's the Total Cut Depth is .75. Changing it does not change the depth of the cut path.
The VeeMill taper is 45 and the letter width is less than 1/2" so the depth should only need to be about 1/2 deep.
The depth seems stuck
Advice?
Thanks
Trying to get the full depth V not a flat bottom on a the letters
The cuts are only going to less than a half inch deep.
The stock thickness H is 2"
In the V-Carving Cut Parameter's the Total Cut Depth is .75. Changing it does not change the depth of the cut path.
The VeeMill taper is 45 and the letter width is less than 1/2" so the depth should only need to be about 1/2 deep.
The depth seems stuck
Advice?
Thanks