Strange toolmarks in rotary toolpath
Posted: Wed Feb 19, 2020 4:13 pm
Hi,
I have a large foam part to route/mill on my machine.
After running a simulation the stock after machining looks as expected with the exception of some strange tool marks? It's a very large part (1500mm x 600mm stock) so the generation of toolpaths and simulation takes forever. Just wondering if someone looks at this and knows exactly what the cause is?
Hoping to save some trial and error.
Toolpath was rotary zig zag. I'm generating a cut along Y axis toolpath now to see if I get a different result. (Y being the axis I revolve around)
Thanks in advance.
I have a large foam part to route/mill on my machine.
After running a simulation the stock after machining looks as expected with the exception of some strange tool marks? It's a very large part (1500mm x 600mm stock) so the generation of toolpaths and simulation takes forever. Just wondering if someone looks at this and knows exactly what the cause is?
Hoping to save some trial and error.
Toolpath was rotary zig zag. I'm generating a cut along Y axis toolpath now to see if I get a different result. (Y being the axis I revolve around)
Thanks in advance.