RhinoCAM 2018 simulation bug. Machined stock model vanishes
Posted: Mon Nov 26, 2018 11:24 pm
Identified in RhinoCAM 2018 v8.0.0.28.
When simulating a part with multiple setups the simulated model vanishes leaving only the toolpaths displayed. Generally the disappearing stock happens in a MOP part way through the second setup and is gone for all MOPs below that. Often the simulation starts ok for the first part of the MOP then suddenly disappears after a few machining levels.
The milling machine is a 3 axis unit and the second setup is usually where the part has been turned over to machine the other side.
When simulating a part with multiple setups the simulated model vanishes leaving only the toolpaths displayed. Generally the disappearing stock happens in a MOP part way through the second setup and is gone for all MOPs below that. Often the simulation starts ok for the first part of the MOP then suddenly disappears after a few machining levels.
The milling machine is a 3 axis unit and the second setup is usually where the part has been turned over to machine the other side.