RhinoCAM 2018 GUI Bug in Horizontal Finishing
Posted: Mon Nov 26, 2018 11:17 pm
Identified in RhinoCAM 2018 v8.0.0.28.
In Horizontal Finishing enter 'Cut Levels' then type in an elevation number into 'Bottom(B)' field, or 'Top (T). The number entered, say '10' becomes '-6.9878' when either 'Save' or 'Generate' is clicked and the weird number is used for the regeneration giving screwy results. Re-enter the 'Cut Levels' dialog and the screwy number is visible in the field. Workaround by using the 'pick' function to select a point on the geometry.
System is in metric mode.
In Horizontal Finishing enter 'Cut Levels' then type in an elevation number into 'Bottom(B)' field, or 'Top (T). The number entered, say '10' becomes '-6.9878' when either 'Save' or 'Generate' is clicked and the weird number is used for the regeneration giving screwy results. Re-enter the 'Cut Levels' dialog and the screwy number is visible in the field. Workaround by using the 'pick' function to select a point on the geometry.
System is in metric mode.