Rookie problem with VCC
-
- Posts: 6
- Joined: Mon May 19, 2014 1:05 pm
Rookie problem with VCC
I am using the nest feature of VCC. I bring in 3 STEP files - one for the sheet and the other two for parts to nest. In the past I could go through the setup by doing box selects followed by a right click. Now when I do that nothing is selected. I assume some option has changed, but maybe it is something else. I can't seem to get things selected to fill out the setup for nesting.
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Rookie problem with VCC
You would need to select Curves to be used as Sheets and Parts when nesting in version 2018.