Bridges/Tabs : Machining Regions
-
- Posts: 10
- Joined: Thu Dec 17, 2015 5:33 pm
Bridges/Tabs : Machining Regions
I am currently using Rhinocam STD 2016
I have a half moon shaped part that I whish to put 2 tabs on the outside arc, I have created a machining region and inserted "manual Bridge points on selections" then cloned to identical geometry, I have tryed selecting the pre defined regions in the control geometry tab, it selects the line but wont create 2 tabs where I have created the bridge points. Am I missing something?
Thanks in advance
David G
-
- Posts: 10
- Joined: Thu Dec 17, 2015 5:33 pm
Re: Bridges/Tabs : Machining Regions
It seems that the tabs have to be "a distance" away from both the start point of the curve and the corners to work, which it now is, If there is a definative distance that I find, I will post here, but for now looks like it may be working well, there are no videos showing this....or are they hidden in mecsoft?