Cross hatching - what machining operation to use
-
- Posts: 2
- Joined: Mon May 16, 2016 10:10 am
Cross hatching - what machining operation to use
I am trying to create a crosshatch pattern on top of a curved surface. It is a knife handle. I don't know what 3D machining process to use. Attached is an image of the design.
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Cross hatching - what machining operation to use
You can program the cross hatch pattern using engraving. This can be located under 2 axis methods.