hole drilling
Posted: Sun Mar 20, 2016 1:49 pm
Hello,
Using rhinocam 2014, 3 axis.
I need to countersink a series of very small holes of varying diameters. I want to do this by drilling (with a chamfer mill) to the depth of a series calculated point.
IS there are way to drill to a series of varying depth points? I have the points depth calculated so that with a 90 deg mill, drilling to the depth will give the needed chamfer/countersink.
But, can seem to find the correct way tot do this in rhinocam.
Any help is appreciated.
Using rhinocam 2014, 3 axis.
I need to countersink a series of very small holes of varying diameters. I want to do this by drilling (with a chamfer mill) to the depth of a series calculated point.
IS there are way to drill to a series of varying depth points? I have the points depth calculated so that with a 90 deg mill, drilling to the depth will give the needed chamfer/countersink.
But, can seem to find the correct way tot do this in rhinocam.
Any help is appreciated.