Keep whole tool, not just tip, in region?
Posted: Tue Feb 23, 2016 12:51 pm
Rhino Cam 2012, Version 3.0.0.48
2 and 3 axis version
Three axis horizontal roughing, parallel finishing keep the tool TIP within the defining region.
Is there any way to easily keep the WHOLE TOOL within the defining region?
I know I can do this by offsetting curves to get a smaller region. But is there some way to tell RhinoCAM
that this is what I want to do? Seems like a pretty common situation ....
2 and 3 axis version
Three axis horizontal roughing, parallel finishing keep the tool TIP within the defining region.
Is there any way to easily keep the WHOLE TOOL within the defining region?
I know I can do this by offsetting curves to get a smaller region. But is there some way to tell RhinoCAM
that this is what I want to do? Seems like a pretty common situation ....