Page 1 of 1
Biesse Post Processor
Posted: Thu Dec 17, 2015 9:09 pm
by joblo
Hello
I am hoping to find a post processor that will work with a Biesse Arrow TCP Router. Does anybody know if that exists or is possible to do?
The machine was manufactured in 2000.
Thanks.
Re: Biesse Post Processor
Posted: Wed Dec 23, 2015 11:11 am
by MecSoft Support
Most Biesse machines require a proprietary CIX format that is not in standard G & M code formats. Only the Rover J series machines that uses NC Studio controller reads G & M codes. Our CAM software only supports and outputs standard G & M code formats. If the Biesse machine that you are considering uses a NC Studio control, we can write a post to output in G & M code format.
Please send an email to
[email protected] with the following information
1. G & M code specifications from the controller manual
2. Information on canned cycles for drilling, tapping, boring operations, (G81 - G89)
3. Arc output formats for Circular interpolations (G02/G03)
4. A sample G code output that works with this machine controller.