Can't select part in RhinoTurn
Posted: Tue Nov 17, 2015 12:00 pm
Hi,
I was following the process that I normally do to process a part. I created the stock to a similar size to the part(slightly oversized) and then tried to define the part. I selected the entire part for the control region and after I clicked save, it still said that no part was selected. When I went back into the part menu there is a surface listed. I clicked on the surface and my part showed a lot of green arrows pointing off in all directions. Do you have any idea how to fix this so that I can select my part to turn it? Thanks.
-Nick
I was following the process that I normally do to process a part. I created the stock to a similar size to the part(slightly oversized) and then tried to define the part. I selected the entire part for the control region and after I clicked save, it still said that no part was selected. When I went back into the part menu there is a surface listed. I clicked on the surface and my part showed a lot of green arrows pointing off in all directions. Do you have any idea how to fix this so that I can select my part to turn it? Thanks.
-Nick