I'm having problems with this part.
Thanks
Hahn Rossman
It seems like the problem is the tool path not the geometry
Any ideas or suggestions?parallel finishing questions
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: parallel finishing questions
From the screen shots it looks like the cut path is parallel to the surface along the length of the part and it is leaving material at the side walls. Changing the angle of cut to 90 degrees in the parallel finishing cut parameters would result in a better finish.
Between 2 curves machining would be good way to finish this part.
Between 2 curves machining would be good way to finish this part.