Page 1 of 1
parallel finishing questions
Posted: Thu Dec 11, 2014 2:44 pm
by hahn_rossman
I'm having problems with this part.
- DSC_0437.JPG (1.74 MiB) Viewed 5736 times
It seems like the problem is the tool path not the geometry
- Screenshot 2014-12-10 22.23.16.png (306.31 KiB) Viewed 5736 times
Any ideas or suggestions?
Thanks
Hahn Rossman
Re: parallel finishing questions
Posted: Fri Dec 12, 2014 3:32 pm
by MecSoft Support
From the screen shots it looks like the cut path is parallel to the surface along the length of the part and it is leaving material at the side walls. Changing the angle of cut to 90 degrees in the parallel finishing cut parameters would result in a better finish.
Between 2 curves machining would be good way to finish this part.