MecSoft Corporation

Just put two new Asus VN248H monitors on my system. I went to the shop and connected to the system via windows Remote desktop for the first time. When I started VisualCad there was some message about graphics, but I didn't pay a lot of attention, since I know the shops graphics are underpowered.

Every mouse move on the screen was causing the graphics to repaint and it wasn't quick. Trying to watch simulate was painful. I figured it was the remote desktop connection, but I am seeing the same thing now that I am back at the system with the two new monitors. I have tried setting the display options back to default along with various other settings and I dropped the resolution back down to what it was before the new monitors, but so far nothing has helped.

So I am not really sure if the new monitors are part of the problem, or if something happened when I connected via remote desktop (ie, clicked OK to a dialog that I shouldn't have) or ??

Any help appreciated.

VisualCAD/Mill 2014
Intel i7-2600 CPU @ 3.40 GHz
8 GB ram
Windows 8.1
DirectX 11
GeForce GTX 460
Driver version 344.65

You could try updating your display drivers and then see if this resolves the issue. If the problem still persists after updating the drivers, try uninstalling & reinstalling VisualCADCAM.

Just wanted to report back that it was the graphics driver. It hadn't been that long since I had installed the existing driver, so they must have had an issue and put out a new one pretty quick.

Thanks.