CUTTER COMP
Posted: Sat Nov 22, 2014 9:30 am
Hi,
Is there a way to turn off the cutter comp in Rhinocam so the machine control can do all the comp with G41/G42? I have a situation where I need the machine to calculate the comp adjustment but I can't get the software to output just G41/G42 without also compensating in the software?
Thanks,
Brandon.
Is there a way to turn off the cutter comp in Rhinocam so the machine control can do all the comp with G41/G42? I have a situation where I need the machine to calculate the comp adjustment but I can't get the software to output just G41/G42 without also compensating in the software?
Thanks,
Brandon.