Page 1 of 1
Training manual 2014
Posted: Sat Nov 01, 2014 11:51 am
by wabecomilluser
Hi. I have been using visualmill 6 standard for a few years now I found the training manual very useful to start with. I am considering upgrading to 2014 standard. Have you produced a manual for this latest software.
Re: Training manual 2014
Posted: Mon Nov 03, 2014 1:55 am
by MecSoft Support
Yes, we have an updated 2014 Training Manual that ships with the product.
Re: Training manual 2014
Posted: Tue Nov 04, 2014 10:26 am
by wabecomilluser
Many thanks Mecsoft. I contacted the UK supplier ( Simply Rhino) regarding upgrading to 2014. I asked about training manual. They said it would have to be obtained direct from you. Is this the case?
Re: Training manual 2014
Posted: Wed Nov 05, 2014 9:11 am
by MecSoft Support
With 2014 version, Getting Started Guide (GSG) has been replaced with Quick Start Guide that ships with the product. The GSG of the 2012 product version should be applicable to the 2014 version since the UI had not changed much.