Page 1 of 1
slow engraving calculation problem
Posted: Sat Sep 06, 2014 2:36 am
by inpro
Hi guys,
I am trying to engrave brick hatch but it is calculated to slow. Is there any solution for speeding up.
Thanks.
Re: slow engraving calculation problem
Posted: Mon Sep 08, 2014 3:52 pm
by MecSoft Support
The engraving operation shows 3221 geometries selected as machining regions and it took about 2 minutes to generate the toolpath in 64 bit version of VisualCADCAM 2014. This seems to be reasonable for this large data set.
Re: slow engraving calculation problem
Posted: Thu Sep 11, 2014 5:59 am
by inpro
Thank you for your response. Honestly I was expecting such answer because I tried playing with all options and did not get faster engraving calculation. Please add my proposal in your customer's wish list: Speed up engraving calculation if you can. Anyway, many thanks for your support.
Best regards.