Hi guys,
I need quick help dealing with small sized balustrade model. The problem is that computing the parallel finishing is very slow with relatively rough model /not too much faces/. The bounding box size is 17-5-1,5 mm. I am using 0,6 mm flat tool because it gives me satisfying result. The material is plastic. When I scale everything 100 times/including the tool/ the speed is OK. Do I miss some tuning? Playing with Part Sampling Resolution gave no result.
Thanks in advance!
small size model problem
small size model problem
- Attachments
-
- balustrade.rar
- (460.85 KiB) Downloaded 1019 times
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: small size model problem
The flat end mill you defined shows a shank diameter of 12mm. Changing this to the diameter of the tool (0.6mm) and regenerating the toolpath should generate the toolpath quickly.
Hope this helps!
Hope this helps!
- Attachments
-
- balustrade-REV1.rar
- (440.52 KiB) Downloaded 1009 times
Re: small size model problem
Thank you for your on time help, really appreciate it !