Problem creating open curve Region
Posted: Fri Jun 22, 2012 2:27 pm
The one thing I have not grasped is how to create a profile toolpath for an open region.
EXAMPLE1. Lets say that one has a D shaped part, where the curve of the D is on the Z plane and one only wished to machine the outer curved surface without profiling all the way around the part.
EXAMPLE2. Or one wished to machine only the outside of the straight part of the D.
How do I go about this . If I select "create single flat area region and select a region, the toolpath go's down the centre of that region. What am I doing wrong?
I would be very greatful if this precedure can be spelt out to me.
I also do not understand now to use the following . In edit curves - Edit surface boundary and Bounding Region.
I have the standard Visualmill 6 package.
Thanks In advance.
EXAMPLE1. Lets say that one has a D shaped part, where the curve of the D is on the Z plane and one only wished to machine the outer curved surface without profiling all the way around the part.
EXAMPLE2. Or one wished to machine only the outside of the straight part of the D.
How do I go about this . If I select "create single flat area region and select a region, the toolpath go's down the centre of that region. What am I doing wrong?
I would be very greatful if this precedure can be spelt out to me.
I also do not understand now to use the following . In edit curves - Edit surface boundary and Bounding Region.
I have the standard Visualmill 6 package.
Thanks In advance.