MecSoft Corporation

Rhino3d file and RhinoCam2.0
Using Roland MDX-650 with tool changer and rotary unit.
Machine stop during finishing run - message reads: " wrong number of parameters " .
After pressing ENTER the bit cuts into the object milling along Y axis
in straight path.
Please help.

We would need to take a look at the Rhino part file (*.3dm) & the posted output file. Is your current post processor set to Roland CAMM-GL or Roland MDX 650 ATC in RhinoCAM?. Could you please upload the part file or email it to [email protected].