Observation - Error?
Posted: Sun May 27, 2012 11:22 am
The post processor for Mach3-Inch includes the starting block;
[START_CHAR]
[SEQ_PRECHAR][SEQNUM][DELIMITER]G00 G49 G40.1 G17 G80 G50 [OUTPUT_MODE_CODE]
[SEQ_PRECHAR][SEQNUM][DELIMITER][OUTPUT_UNITS_CODE]
According to Mach3 (Artsoft) G40.1 is not supported. In fact, I cannot find any reference to G40.1 anywhere.
Should this be changed to G40, or does it have another significance?
Thanks
Mike aka Groundhog
[START_CHAR]
[SEQ_PRECHAR][SEQNUM][DELIMITER]G00 G49 G40.1 G17 G80 G50 [OUTPUT_MODE_CODE]
[SEQ_PRECHAR][SEQNUM][DELIMITER][OUTPUT_UNITS_CODE]
According to Mach3 (Artsoft) G40.1 is not supported. In fact, I cannot find any reference to G40.1 anywhere.
Should this be changed to G40, or does it have another significance?
Thanks
Mike aka Groundhog