MecSoft Corporation

I can't get this to pocket. It hard crashes Rhino every time.

It's a V5 file, I did save it down to V4 and tried there same thing.

ended up getting it, i had to redraw the outside circle, export the curves as a dxf and re-import them and use them, why this worked I have no clue.

Something in the original geometry is causing the crash. We will take a look.

Any further info on this? I'm posting (right now) a crash problem?

The Rhino file included in the thread shows several errors when loading in Rhino. As this seem to be a Rhino file load related issue, we would recommend that you contact Rhino technical support.