MecSoft Corporation

I am used to the side menu on V6
a pull down for V7
would be nice
to save some screen space

ok this works the Command Bar Visibility turns off the points, arc, curves etc. menu
very nice

two more things
under each draw group for example the ( point and lines box )
do we need the same words underneath them also ( point, lines, lines about )

and how do I add a reverse, change start button to the main menu so I do not have to use the
Command Bar Visibility when programming
just trying to get more screen size

Hi megclay,

glad you were able to find the "Command Bar Visibility" button that will give you more display space than in V6. We actually did think through this!

Regarding group captions, some people like this. We can see if we can add this as a preference to turn off or on.

Regarding adding the buttons for Curve start point and reverse to the main toolbar - you cannot do this just yet. This is because the prompt and command input fields have been integrated into the Command Bar. Since they have to go together commands cannot be customized out of the Command Bar.