erasing Mops from list
Posted: Wed Aug 17, 2011 2:05 pm
My questions are
1 Supposing one wished to remove an Mop that had been created. How can it be removed. There appears to be no erase button. The only way I can think of is to cut and paste to move it some where outside Visualmill .
2. I wrote a program which required a tool to be changed after one profile so that the part could be profiled using a smaller cutter. I expected the program to stop after each part program to allow me to change cutters. Instead it carried on to the next cut profile. What am I doing wrong.
3. I have not grasped when it is necessary to start a new Mop set . The tutorials show many tool statigies in only one set.
I love this software but dispite reading the manual and tutorials have loads of questions which I will ask in small batches!
Thanks in advance. John (new to Visialmill)
1 Supposing one wished to remove an Mop that had been created. How can it be removed. There appears to be no erase button. The only way I can think of is to cut and paste to move it some where outside Visualmill .
2. I wrote a program which required a tool to be changed after one profile so that the part could be profiled using a smaller cutter. I expected the program to stop after each part program to allow me to change cutters. Instead it carried on to the next cut profile. What am I doing wrong.
3. I have not grasped when it is necessary to start a new Mop set . The tutorials show many tool statigies in only one set.
I love this software but dispite reading the manual and tutorials have loads of questions which I will ask in small batches!
Thanks in advance. John (new to Visialmill)