Drill Cycle and Clearance Plane
-
- Posts: 2
- Joined: Tue Feb 02, 2010 9:01 pm
Drill Cycle and Clearance Plane
I have a 3 hole pattern with an obstacle in the middle. Even though I set part max+ .250 for the transfer clearance I get no part max +.250 clearance. I only get R+.1 . Broken bit when it doesn't jump over the obstacle between holes. Simulation is correct but not the post.What do I do to correct the post process generator to return the Z to clearance plane between holes so it does not hit the obstacle??
-
- Posts: 2
- Joined: Tue Feb 02, 2010 9:01 pm