VisualMILL 6.0.7.3 Update Ready for Download!
Posted: Thu Feb 24, 2011 10:10 am
An update for VisualMILL 6.0 is available now for immediate download at:
http://www.mecsoft.com/DownloadVisualMILL.shtml
Please completely un-install VisualMILL 6.0 before installation of the update. Also make sure if you have any customized post processors to save them off BEFORE you uninstall the program.
The version numbers on this update are VisualMILL 6.0.7.3.
It is not necessary to upgrade VisualCAM 1.0 for this update
For changes in this update refer to:
www.mecsoft.com/Downloads/VM6.0.7.3RC2.0.4.3Changes.pdf
http://www.mecsoft.com/DownloadVisualMILL.shtml
Please completely un-install VisualMILL 6.0 before installation of the update. Also make sure if you have any customized post processors to save them off BEFORE you uninstall the program.
The version numbers on this update are VisualMILL 6.0.7.3.
It is not necessary to upgrade VisualCAM 1.0 for this update
For changes in this update refer to:
www.mecsoft.com/Downloads/VM6.0.7.3RC2.0.4.3Changes.pdf