HeidenHain 530 Drilling Post Processor

JVidal · Post by **JVidal** » Tue Feb 22, 2011 2:09 am

Hi,

I've been trying to setup a drilling post-processor for an HeidenHain 530 controller.

The problem is when I check the "Optimize Cycle Output" box. I need a CYCL CALL or a M99 command to be output after each hole coordinate.

An example of what I need is in attach.

JVidal · Post by **JVidal** » Mon Feb 28, 2011 9:12 am

Anyone??

DareBee · Post by **DareBee** » Mon Feb 28, 2011 10:37 am

No, I don't think you can do it that way.

You have to NOT use the optimize function so that it will output everything long form (way long) and catch the M99 that you will have being output with your drill cycle.