Post Processor for Wire EDM
Posted: Fri Feb 04, 2011 2:41 am
I'm trying to setup a post for a WireEDM machine.
I've got it almost completely done, but I'm struggling to get a few codes on the correct place.
I need to insert specific M codes at the beggining and end of each profile
to be cut. These are M codes for cutting and inserting the wire.
In attach there's an example of what I need.
Any help is much appreciated.
Thanks.
I've got it almost completely done, but I'm struggling to get a few codes on the correct place.
I need to insert specific M codes at the beggining and end of each profile
to be cut. These are M codes for cutting and inserting the wire.
In attach there's an example of what I need.
Any help is much appreciated.
Thanks.