All topics related to RhinoCAM
-
juliao
- Posts: 98
- Joined: Wed Dec 31, 2008 3:01 pm
- Location: Marinha Grande Portugal
Post
by juliao »
Hello everyone.
Wonder if it wasn´t possible in hole pocketing just a clean up passage at the end and not in all levels..
Hole take an eternity to do if we want to leave the bottom straight.
Thanks
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
-
Contact:
Post
by MecSoft Support »
This can be done by setting the value of Stepdown Control (dZ) as Distance = the Hole Depth. Make sure you have cleanup pass at each Z level selected.
In the attached picture Hole Depth = 1 and Stepdown Control(dZ) is set to Distance =1
-
Attachments
-
- HolePocketing.jpg (24.07 KiB) Viewed 4821 times
-
juliao
- Posts: 98
- Joined: Wed Dec 31, 2008 3:01 pm
- Location: Marinha Grande Portugal
Post
by juliao »
Thanks a lot..that will be very usefulll for me..i do a lot of hole pocketings but didn´t know about that option available..
Regards..
António julião