How has the response been to the new product?
I have some concerns about mixing cad and cam.
Response to new product
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
The response has been very good. We have a lot of customers who have switched over to the VM4SW from standalone VM. On the other hand, there are a lot of customers who prefer the standalone VM for various reasons. Some of the main ones are:
1) They are running multiple CAD systems
2) They are using CAM only on the shop floor
3) There are some features in VisualCAM that are not available in SolidWorks (some CAD features such as flat area region generation, STL machining etc.)
Hope this helps.
1) They are running multiple CAD systems
2) They are using CAM only on the shop floor
3) There are some features in VisualCAM that are not available in SolidWorks (some CAD features such as flat area region generation, STL machining etc.)
Hope this helps.
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact: