hello here,
my question is about speeds when mill is changing directions. is it possible set it in rhnocam2? i mean ..get nice smooth speeds vhen curving corners or if changing directions back and forward. eliminate vibrations. i am out of ideas. i running mach 3 on other side.
peter
smooth motion when spindle change direction
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
In RhinoCAM you can use the following techniques to get a smoother tool motion or high-speed machining motions:
1) Perform cut corner rounding
2) Arc fitting to toolpaths
3) Smooth Cut transfers
4) Radial Cut connections with Loops
All of these will smooth out the toolpaths and cut connections to reduce abrupt changes in toolpath motions. These techniques are specific to toolpath methods that is, not all of them are available in all toolpath methods.
1) Perform cut corner rounding
2) Arc fitting to toolpaths
3) Smooth Cut transfers
4) Radial Cut connections with Loops
All of these will smooth out the toolpaths and cut connections to reduce abrupt changes in toolpath motions. These techniques are specific to toolpath methods that is, not all of them are available in all toolpath methods.