MecSoft Corporation

I just downloaded VisualMill (yesterday 9-8-09). When starting it up, Solidworks starts OK. Checked that VisualMill is attached as an active add-in.

When I open a part, I get the VisualMill Splash Screen, which appears for a few seconds, then Solidwoks crashes and closes.

Any sugestions? Is VisualMill compatible with SW 2007 sp 0.0?

VisualMILL for Solidworks works only on 2008, 2009 and 2010 (Beta). Previous versions are not supported. Sorry, this is because Solidworks changed their API quite dramatically after 2007.

P.S: FYI, I had the administrator move your posting to the appropriate forum.