RhinoCAM doesn't follow the profiles...

Mitch Heynick · Post by **Mitch Heynick** » Mon Apr 27, 2009 2:11 pm

This looks like a bug here, or I'm doing something really wrong... In the attached, RhinoCAM just "cuts off" the inner tabs on these closed profiles. If you open one end up the profiles program correctly. The curves all look correct and pass check in Rhino (they're really simple...)

--Mitch

Mitch Heynick · Post by **Mitch Heynick** » Mon Apr 27, 2009 2:16 pm

Sorry, wrong file attached - this should be the correct one.

--Mitch

Post by **MecSoft Support** » Mon Apr 27, 2009 5:26 pm

Mitch,

Explode all the curves and join them back and generate the toolpath. This seems to fix the problem.

Mitch Heynick · Post by **Mitch Heynick** » Tue Apr 28, 2009 2:04 pm

OK, thanks. Since Rhino did not detect anything wrong with the original curves, what is wrong with them? --Mitch