I'm also posting this to the Rhino newsgroup...
If I have RhinoCAM 2 loaded, and I need to run my laser at the same time - when I run the Print command to send a file to the laser (Epilog) all the no-print stuff shows up in the print preview window... and then it gets cut with the laser!
NoPrint attributed curves are not supposed to print/cut, and they don't if RhinoCAM is not loaded.
I have no idea on which end the problem is so I'm informing both sides... I hope this can get fixed soon, though, it's annoying (I have to unload RhinoCAM) and possibly dangerous (if I forget to do so).
Thanks, --Mitch
RhinoCAM 2 + Laser cutting - Aieee... !
-
- Posts: 488
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Switzerland
- Contact:
-
- Posts: 488
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Switzerland
- Contact: