All topics related to RhinoCAM
-
Hoop
- Posts: 23
- Joined: Tue Sep 02, 2008 3:24 am
Post
by Hoop »
I can't seem to get this feature to work.
I am using "deep drill" to drill a .5 inch hole. I set it to .065 increments.
The resulting tool path is just .5 in one operation.
-
postalgbv
- Posts: 59
- Joined: Sat Oct 04, 2008 7:19 pm
Post
by postalgbv »
if you do a post, does it have g83 command?
-
Hoop
- Posts: 23
- Joined: Tue Sep 02, 2008 3:24 am
Post
by Hoop »
.5 with .1 increments. 1/4" bit:
G00 G49 G40.1 G17 G80 G50 G90
G20
(Deep Drill )
M6 T17
M03 S10000
G01 X3.2500 Y1.0000 Z0.1250 F20.0
G83 X3.2500 Y1.0000 Z-0.5722 R0.1 Q0.1
G80
G01 Z0.1250 F20.0
M5 M9
M30
-
postalgbv
- Posts: 59
- Joined: Sat Oct 04, 2008 7:19 pm
Post
by postalgbv »
g83 is peck drilling command, so it should work fine I think. I don't think the Rhinocam simulation shows the 'pecking' though.
-
Hoop
- Posts: 23
- Joined: Tue Sep 02, 2008 3:24 am
Post
by Hoop »
Ahh I see. Thanks for the reply.
I just assumed based on the simulation that it was not pecking.