Page 5 of 5
Posted: Wed Dec 08, 2010 3:52 am
by Mark Angus
Hi Mecsoft
Is there any useable beta versions out yet for the 5 axis module. I would like to try a RhinoCAM one if possible when it is ready. I think MadCAM is trying to catch up!
http://www.madcamcnc.com/news.html
Posted: Tue Feb 15, 2011 11:12 am
by Mark Angus
Hi Mecsoft.
Are you still planning on releasing a 5 axis continuous module?
Mark
Posted: Thu Feb 17, 2011 11:27 am
by MecSoft Support
Yes!
Posted: Fri Jul 01, 2011 5:10 am
by Mark Angus
Hi Mecsoft
Is there any progress you can show us?
Mark
Posted: Fri Jul 01, 2011 9:02 am
by MecSoft Support
Hi Mark,
Ok, we in the final stretch here. We will have a Beta release end of next week. This will include the new 5 Axis module. We will let you know once this is launched so you can sign up and have access to the Beta software. We will release the product once we feel it is production ready after getting feedback from users.
Hope this helps.
Re: Vm6 5 axis continuous?
Posted: Fri Jul 29, 2011 9:33 am
by Mark Angus
Hi Mecsoft
Is a Beta ready yet?
Mark
Re: Vm6 5 axis continuous?
Posted: Fri Jul 29, 2011 10:38 am
by MecSoft Support
Mark you should have access to the beta forum. Don't you see it at the bottom of this forum?
Re: Vm6 5 axis continuous?
Posted: Fri Jul 29, 2011 3:30 pm
by Mark Angus
Cool found it. Will try it tomorrow.
Re: Vm6 5 axis continuous?
Posted: Tue Oct 04, 2011 11:52 am
by jesuslopez
hi!
Any news for 5 axis continuous?
Jesus Lopez
Re: Vm6 5 axis continuous?
Posted: Wed Oct 05, 2011 8:43 am
by MecSoft Support
Please see posting above yours.
Re: Vm6 5 axis continuous?
Posted: Wed Oct 05, 2011 11:39 am
by jesuslopez
I can´t find Beta Forum. Where is it?
Jesus Lopez
Re: Vm6 5 axis continuous?
Posted: Thu Oct 06, 2011 8:26 am
by MecSoft Support
The beta is open only to customers. Please send your customer information to
[email protected] and we will allow access to the Beta forum. Thanks.