Default orient geometry

[Hoop]

In the help section under "orient part" it says:

"This dialog offers a convenient way of selecting each of the six principal directions to set the cutting direction"

Yet there are only 5 radio buttons. I have set the orientation to something other than default, how do I change it back to default?

http://img120.imageshack.us/my.php?imag ... camcr8.jpg

[MecSoft Support]

Select the same button again to reset the orientation back to the original orientation.

You can also use the Rhino rotation tools to orient the geometry back.

[Hoop]

Using the same radio button doesn't actually work in the manner expected. It sends the part off into the distance with each press.

Rhino tools will get it back to orientation though. Ctrl Z works.

Thanks for the reply.