No clearance plane on tapping
Posted: Fri Jun 04, 2004 10:56 am
%
N2G00G40G49G80G90G17
N3 (Clockwise tap operation)
N4T7M6
N5G0G90G57X3.125Y-0.22 M08 S200M3
N6Z5.2601H7
N7G84.2
N8Z2.518
N9G84.1R2.518X3.125Y-0.22Z0.718F10.0S200
N12X3.1251Y-2.28
N15X3.125Y-15.72
N18X3.125Y-17.78
N21X17.875Y-17.78
N24X17.8749Y-15.72
N25G80
N26M05
N27G91G28Z.0
N28G00G90E0X0Y9.
N29M19
N30M30
%
As you can see my Clearance plane is N6
Starting in N12 my tap is going from hole to hole and it is doing so at the set approach distance height. I had VM set for clearance plane!
I broke a tap off the first time it didnt clear my pocket and then I set my approach distance reall high to complete the job. Sure doubled the process time though.
What is wrong that it is not returning to clearance plane?
N2G00G40G49G80G90G17
N3 (Clockwise tap operation)
N4T7M6
N5G0G90G57X3.125Y-0.22 M08 S200M3
N6Z5.2601H7
N7G84.2
N8Z2.518
N9G84.1R2.518X3.125Y-0.22Z0.718F10.0S200
N12X3.1251Y-2.28
N15X3.125Y-15.72
N18X3.125Y-17.78
N21X17.875Y-17.78
N24X17.8749Y-15.72
N25G80
N26M05
N27G91G28Z.0
N28G00G90E0X0Y9.
N29M19
N30M30
%
As you can see my Clearance plane is N6
Starting in N12 my tap is going from hole to hole and it is doing so at the set approach distance height. I had VM set for clearance plane!
I broke a tap off the first time it didnt clear my pocket and then I set my approach distance reall high to complete the job. Sure doubled the process time though.
What is wrong that it is not returning to clearance plane?