MecSoft Corporation

Hello all

I have a customer machining in Rhinocam pro with 5 axis indexed.

In the link bellow the customer can't make rhinocam rotate the 4 and 5 axis , this is done in the axis B and C but
seems that in the output is not done.

http://www.paraglobal-3d.com/download/p ... upport.rar

What are we missing here?

Regards
Sergio Silva

Hello Sergio,

The post processors for RhinoCAM 1.0 are setup for 2 1/2, 3 axis 4 axis. You would need obtain a custom post for 5 axis.
Please contact [email protected] for information on 5 axis posts.