Training manual 2014

[wabecomilluser]

Hi. I have been using visualmill 6 standard for a few years now I found the training manual very useful to start with. I am considering upgrading to 2014 standard. Have you produced a manual for this latest software.

[MecSoft Support]

Yes, we have an updated 2014 Training Manual that ships with the product.

[wabecomilluser]

Many thanks Mecsoft. I contacted the UK supplier ( Simply Rhino) regarding upgrading to 2014. I asked about training manual. They said it would have to be obtained direct from you. Is this the case?

[MecSoft Support]

With 2014 version, Getting Started Guide (GSG) has been replaced with Quick Start Guide that ships with the product. The GSG of the 2012 product version should be applicable to the 2014 version since the UI had not changed much.