Hi, I was wondering if it is possible to set the profiling operation to ramp in on each successive level of cutting? It ramps on the first pass but not on the passes following the first. I looked around the forum a bit and couldn't find anything on this particular item so just wondering if anyone knows how to do this?
For whatever it's worth I love this software and I think it has a lot of potential. For anyone who can't make up their mind if it's worth buying...you can't beat the company input and assistance!
Thanks Jesse
Ramping for each depth of cut
-
- Posts: 31
- Joined: Mon May 19, 2014 1:05 pm
Re: Ramping for each depth of cut
Hi Jesse,
Have you tried checking the box called "apply entry/exit at each cut level" ?
-Brandon
Have you tried checking the box called "apply entry/exit at each cut level" ?
-Brandon
-
- Posts: 20
- Joined: Mon May 19, 2014 1:05 pm
Re: Ramping for each depth of cut
Ahh, right in front of me That does what I needed, thanks for your help!
Jesse
Jesse
-
- Posts: 31
- Joined: Mon May 19, 2014 1:05 pm
Re: Ramping for each depth of cut
Your welcome Jesse. That button seems to get missed often. I'm guessing because it's in the lower left corner.
-Brandon
-Brandon