post processor drilling cycle

All discussion related to the VisualCAD/CAM standalone product.
Post Reply
pfiske
Posts: 6
Joined: Sat Mar 07, 2009 11:01 am
Location: Wilmington, Mass, USA
Contact:
Contact pfiske

post processor drilling cycle

Post by pfiske »

I am trying to set up the post processor deep drilling for a Precix router built in 2002. I need the output to be a string of G0 and G1 commands. Any ideas?
Top
JVidal
Posts: 72
Joined: Fri Jan 08, 2010 7:38 am
Location: Portugal
Contact:
Contact JVidal

Post by JVidal »

not sure if this is what you are looking for, or if it will work on your machine but...

http://www.mecsoft.com/phpbb/viewtopic.php?t=2492
Best regards
JVidal
Top
Post Reply

Return to “VisualCAD/CAM Topics & Support”