could the "create tool" dialog provide an option to define a shank diameter that differs from the diameter at the flutes?
similar to center drills, tools that have a varying diameters (e.g. 6mm at the shank to e.g. 3mm) are quite common, aren't they? .
the aim would be to calculated collisions between part and shank.
since user-defined tools are only for 2-1/2d, this is not an option.
does this make sense?
best,
frank
feature request: tool shank diameter definition
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact: