This looks like a bug here, or I'm doing something really wrong... In the attached, RhinoCAM just "cuts off" the inner tabs on these closed profiles. If you open one end up the profiles program correctly. The curves all look correct and pass check in Rhino (they're really simple...)
--Mitch
RhinoCAM doesn't follow the profiles...
-
- Posts: 488
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Switzerland
- Contact:
RhinoCAM doesn't follow the profiles...
- Attachments
-
- RCError.zip
- (19.47 KiB) Downloaded 691 times
-
- Posts: 488
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Switzerland
- Contact:
Sorry, wrong file attached - this should be the correct one.
--Mitch
--Mitch
- Attachments
-
- RCError-2.zip
- (19.52 KiB) Downloaded 685 times
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Mitch,
Explode all the curves and join them back and generate the toolpath. This seems to fix the problem.
Explode all the curves and join them back and generate the toolpath. This seems to fix the problem.
- Attachments
-
- RCError-2_REV1.zip
- (25.98 KiB) Downloaded 682 times
-
- Posts: 488
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Switzerland
- Contact: