RhinoCam 1.0(SP2) - Can't find the Toolpath Editor

Macko · Post by **Macko** » Tue Mar 24, 2009 2:56 pm

Testing RhinoCam after VisualMill. This is an amazing possibility not having to leave Rhino - Thank you for a good product.

I just can't seem to find the function that in VisualMill 5 activated by a small hammer-icon "Toolpath Editor". Then in the opened function window we had 18 icons, like "Cut Selected Motions" that can be rather useful. It also showed the G-code and on the bottom the "Toolpath Information".

Thank you for the answer in advance.
Macko

Post by **MecSoft Support** » Wed Apr 01, 2009 3:56 pm

Macko,

From the MOps tab, double click on Toolpath under a machining operation and this would load the Toolpath Editor.

Hirudin · Post by **Hirudin** » Sat Apr 18, 2009 3:37 am

It's too bad this was removed in RhinoCAM 2.0!

Please tell me I'm mistaken.

Post by **MecSoft Support** » Sat Apr 18, 2009 2:21 pm

No it was not removed in RhinoCAM 2.0 - in fact we have enhanced it to include selection of motions with regions. In case you don't have access to it from RhinoCAM 2.0, you must be running the STD configuration of the product. It is only available in the PRO configuration.