Problem with edges.pls help me

strme · Post by **strme** » Sun Dec 14, 2008 4:30 pm

hei,
guys pls help with this problem. i can not make it correct. i have so bad days. angry now

i using rhinocam1.0 with mach3. postprocessor is from website here.
ehm, the problem is this cascades on sidewalls. they must be nice clear and in 90angle.

Post by **MecSoft Support** » Mon Dec 15, 2008 10:27 am

Hi,
It is hard to help you without additional information. Please send us the Rhino model with toolpaths and operations so we can see what methods you are using. You can send it to [email protected]
Also tell us if you have had this problem before or is this specific to a part file.

strme · Post by **strme** » Mon Dec 15, 2008 1:54 pm

all ready i send you file. if some problem with file..let me know. the problem is always i making some parts. i have some g-codes from lazycam and is ok. but rhino is rhino. so good 3D modeling and cam with it. this is everything what i need. but...

Post by **MecSoft Support** » Thu Dec 18, 2008 9:41 am

We reviewed your file and replied to your email on 12/15/08.
The following suggestions were made
1. Select Preferences from the Setup tab in RhinoCAM. Uncheck output arcs as linear segments.
2. Edit the 2 1/2 axis profiling operation. Change the tolerance from 0.03 to 0.01.

Attached is a screen capture of simulation & toolpath preview (posted for Mach3).

strme · Post by **strme** » Thu Dec 18, 2008 3:06 pm

yes, i have mail from you.
i will post here report later..

thanks

strme · Post by **strme** » Sat Apr 04, 2009 2:35 pm

helou.
so, i am back again. my report is not so positive.(still the same problem) i don't know what to say. where can find the way to rapair that.?

Post by **MecSoft Support** » Mon Apr 06, 2009 11:59 am

We have verified the toolpath and the posted code. They look correct in RhinoCAM, Xpert CNC Editor's backplot and Mach3. Attached zip file contains the Rhino file, posted g-code, screen captures of toolpath preview and Mach 3 Post.
As we cannot see any issues with the posted code, it could be a machine related issue. We would suggest you contact your machine tool vendor.

strme · Post by **strme** » Fri Apr 10, 2009 2:19 am

ok. very thanks for your answers. this is what i want hear from you.
i going to kick somebody (builders of cnc)

have nice day

peter