Roland MDX-650 acceleration

orvis wustl · Post by **orvis wustl** » Wed Mar 04, 2009 2:28 pm

Having what Roland thinks is a Machine acceleration issue that reads to machinea as y or xy motor lock. where is that value set in RhinoCam 2.0. most often happens in swirling horizontal roughing.

Post by **MecSoft Support** » Wed Mar 04, 2009 4:01 pm

I am not sure I understand your problem. But we cannot control the machine acceleration in RhinoCAM - only the feed rates. Please look at reducing the feedrates in the Feedrate dialog to see if your problem goes away.